Hanging instructions

  1. Picture: Important: Always start installing...
    1 Important: Always start installing the wallpaper from the left in numerical order. Start with panel number 1, continue to the last one. Due to the ordered width it could happen that the last length shows an unprinted, white section. This may have to be trimmed.

    Cut the rolls along the indicated lines and lay out the lengths so that they run in the right direction. The underlying surface must be smooth, dry, free of grease, and uniform in colour.
  2. Picture: Apply adhesive with a lamb’s wool...
    2 Apply adhesive with a lamb’s wool roller or a block- brush. Apply a thin uniform layer of adhesive to the wall. It is important to cover the entire area since missing a spot will result in an air bubble beneath the wallcovering.
  3. Picture: Fold the length in two with the...
    3 Fold the length in two with the printed surface on the inside to avoid getting any adhesive on that side. Place the first length perfectly straight against the wall before pressing and smoothing it onto the underlying surface. If incorrectly placed, remove it and start over.Try never to replace a length.
  4. Picture: Use a wallpaper...
    4 Use a wallpaper foam-rubber-roller/spatula to get the wallpaper smoothly onto the wall and to re- move excess adhesive and air bubbles. Keep the wallcovering clean. Always wipe the spatula clean. Work from top to bottom and from the middle to the edges.
  5. Picture: After applying two drops, assess the...
    5 After applying two drops, assess the result and check to make sure that the pattern matches perfectly from one drop to the next. Immediately remove excess paste using a sponge and clean water.
  6. Picture: Using a steel straightedge and a...
    6 Using a steel straightedge and a sharp knife, trim off excess wallcovering.
  7. Picture: Repeat steps 2 through 6 until the...
    7 Repeat steps 2 through 6 until the wallcovering is entirely pasted.Then admire the result.

Customer Service

+31 35 5264442